Welcome to PacificValves.com

TPR Temperature and Pressure Relief Valve UK Standard

More Views

TPR Temperature and Pressure Relief Valve UK Standard
TPR Temperature and Pressure Relief valves are installed to protect water heaters or water storage tanks from excessive temperature or pressure.

Manufacturer: CASH ACME

WRAS No. 0412080 UK

Connections:
MBSP . . . . . . . . . . . . . Inlet Connections
TPR Temperature and Pressure Relief Valve UK Standard

TPR-15 7 Temperature and Pressure Relief Valve 1/2" 7 Bar

US$18.90
  • Buy 50 for US$15.12 each and save 20%
TPR Temperature and Pressure Relief Valve UK Standard

TPR-15 10 Temperature and Pressure Relief Valve 1/2" 10 Bar

US$18.90
  • Buy 50 for US$15.12 each and save 20%

TPR Domestic Temperature and Pressure Relief Valves are designed for the protection of hot water heaters and storage tanks. These meet WRAS No. 0412080 standards and are ideal for most domestic water heater applications

Available set pressures . . . . . . . 7 Bar and 10 Bar
Temperature relief  . . . . . . . . 90-95C
Service . . . . . . . . . . . . . . . . . . . . Hot water

 
Materials:
Body . . . . . . . . . . . . . . . . . . . . . . Bronze
Seal . . . . . . . . . . . . . . . . . . . . . . . ABS
Lever . . . . . . . . . . . . . . . . . . . . . . Polymide
Compression Nut & Olive  . . . .Brass
Diaphragm  . . . . . . . . . . . . . . . . .EPDM

The Temperature and Pressure Relief Valve is completely automatic and will re-seat after either temperature or pressure relief. Provides protection to EN1490 from the dangerous build up of pressure which can be caused by overheating within an unvented hot water system
The valve is designed to be fitted in the upper portion of the cylinder as this is where the hottest system temperatures will be found. If the system temperature rises beyond 95C the wax mixture within the element of the temperature probe will expand and this will lift the valve off of it's seat and relive water to waste and therefore reducing the pressure inside the cylinder.
Incorporates an inert thermal element coating: Provides effective isolation from mineral deposits (liming) and galvanic corrosion. Completely automatic and reseats after temperature or pressure relief: Ideal for all domestic water heater applications. Fully approved by WRAS (UK) for use on unvented hot water systems. Every valve is tested for performance prior to shipping: Specify and install with confidence!
Available set pressures . . . . . . . 7 Bar or 10 Bar Available sizes ...............................1/2" only For Temperature and Pressure Relief Valves to Australian Standard go to Pressure and Temperature Relief Valves AU UK Standard go to Pressure and Temperature Relief Valves UK